Nortel 8300 Troubleshooting Manual page 148

148 Troubleshooting tools
Specifying the CPU utilization percentages
Use the following procedure to specify the CPU utilization percentage above
which tracing is enabled and the CPU utilization percentage below which
auto-trace is disabled.
Procedure steps
Step
1
2
Variable definitions
Variable
high-percentage <percent>
low-percentage <percent>
Specifying the time to monitor CPU utilization
Use the following procedure to specify the time to monitor CPU utilization
before triggering or disabling a trace.
Procedure steps
Step
1
2
Copyright © 2007, Nortel Networks
.
Action
To specify the CPU utilization percentage above which auto trace
must be enabled, enter the following command.
trace auto-enable high-percentage <percent>
To specify the CPU utilization percentage below which auto-trace is
disabled, enter the following command:
trace auto-enable low-percentage <percent>
Action
To specify the time (in seconds) to monitor CPU utilization before
triggering a trace, enter the following command.
trace auto-enable high-track-duration <seconds>
To specify the time (in seconds) to monitor CPU utilization before
disabling the trace, enter the following command:
trace auto-enable low-track-duration <seconds>
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
—End—
Value
percent is a value from 60 to 100.
The default is 90.
percent is a value from 50 to 90. The
default is 75.
—End—