Nortel 8300 Troubleshooting Manual page 152

152 Troubleshooting tools
Step
1
2
Variable definitions
Variable
high-percentage <percent>
low-percentage <percent>
Specifying the time to monitor CPU utilization
Use the following procedure to specify the time to monitor CPU utilization
before triggering or disabling a trace.
Procedure steps
Step
1
2
Variable definitions
Copyright © 2007, Nortel Networks
.
Action
To specify the CPU utilization percentage above which auto trace
must be enabled, enter the following command.
trace auto-enable high-percentage <percent>
To specify the CPU utilization percentage below which auto-trace
should be disabled, enter the following command:
trace auto-enable low-percentage <percent>
Action
To specify the time (in seconds) to monitor CPU utilization before
triggering a trace, enter the following command.
trace auto-enable high-track-duration <seconds>
To specify the time (in seconds) to monitor CPU utilization before
disabling the trace, enter the following command:
trace auto-enable low-track-duration <seconds>
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
—End—
Value
percent is a value from 60 to 100.
The default is 90.
percent is a value from 50 to 90. The
default is 75.
—End—