Nortel 8300 Troubleshooting Manual page 151

Variable definitions
Variable
<level>
<modid>
Removing a module
Use the following procedure to remove a module from automatic tracing.
Procedure steps
Step
1
Variable definitions
Variable
<modid>
Specifying the CPU utilization percentages
Use the following procedure to specify the CPU utilization percentage above
which tracing is enable and the CPU utilization percentage below which
auto-trace should be disabled.
Procedure steps
Copyright © 2007, Nortel Networks
.
Action
To remove a module that is being traced by the trace auto-enable
feature, enter the following command.
trace auto-enable remove-module <modid>
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
Configuring an automatic trace 151
Value
Identifies the level of detail you want in
the trace. For example, 0 = Disabled, 1
= Very Terse. The valid range is 0 to 7.
Identifies the module that you want to
add. For example, 3 = Port Manager,
20 = Topology Discovery. The valid
range is 0 to 66. For a list of valid
module IDs, enter trace level ?.
—End—
Value
Identifies the module for which you want
to disable auto-trace. For example,
3 = Port Manager, 20 = Topology
Discovery. The valid range is 0 to 66.
For a list of valid module IDs, enter
trace level ?.