Nortel 8300 Troubleshooting Manual page 93

11
12
13
14
Variable definitions
Variable
address <ipaddr>
facility <facility>
host <id>
host <id> <enable|dis
able>
maperror <level>
mapfatal <level>
mapinfo <level>
mapwarning <level>
Copyright © 2007, Nortel Networks
.
config sys syslog host <id> severity <info|warning|e
rror|fatal>
To enable the sending of syslog message on the switch, enter the
following command:
config sys syslog state enable
To enable the syslog host; enter the following command:
config sys syslog host <id> enable
To display the current syslog settings, enter the following command:
config sys syslog info
To display system log information for a specified host, enter the
following command:
config sys syslog host <id> info
Value
The IP address of the system syslog host.
The system syslog host facility (LOCAL0 to LOCAL7).
The default is LOCAL7.
The syslog host ID. The range is 1 to 10.
Enables or disables the syslog host. The default is
disable.
The syslog severity to use for error messages.
level is {emergency|alert|critical|error|wa
rning|notice|info|debug}. The default is error.
The syslog severity to use for fatal messages.
level is {emergency|alert|critical|error|
warning|notice|info|debug}. The default is
emergency.
The syslog severity level to use for information
messages.
level is {emergency|alert| critical|error|w
arning|notice|info|debug}. The default is info.
The syslog severity to use for warning messages.
level is {emergency|alert| critical|error
|warning|notice|info|debug}. The default is
warning.
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
—End—
Using syslog 93