Nortel 8300 Troubleshooting Manual page 110

110 Troubleshooting tools
To configure VCT from the interface configuration mode, use the following
command:
Passport-8310:5(config)# int fast 4/1
To configure and enable VCT, use the following command:
Passport-8310:5(config)# vct test
Figure 13 "VCT test command output" (page 110)
configured on port 4/1.
Figure 13
VCT test command output
To display VCT information, use the following command:
Passport-8310:5# show vct 4/1
Figure 14 "Show vct command output" (page 111)
for this command.
Copyright © 2007, Nortel Networks
.
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
shows a VCT test
shows sample output