Configuring Port Mirroring Using The Cli - Nortel 8300 Troubleshooting Manual

Configuring port mirroring using the CLI
The following configuration examples use the commands described
previously to perform the following tasks:
•
•
•
•
•
•
•
Example 1
To set up ingress port mirroring and set the mode to receive, use the
following command:
Passport-8310:5/config/diag/mirror-by-port/1# create
in-port 1/1 out port 5/4 mode rx enable true
Example 2
To delete mirroring on a port, use the following command:
Passport-8310:5/config/diag/mirror-by-port/1# delete
Example 3
To change the port mirroring mode to mirror both transmit and receive
packets, use the following command:
Passport-8310:5/config/diag/mirror-by-port/1# mode both
Example 4
To change a mirrored port, use the following command:
Passport-8310:5/config/diag/mirror-by-port/1#
mirrored-port 1/3
Example 5
To disable port mirroring on port 1, use the following command:
Passport-8310:5/config/diag/mirror-by-port/1# enable
false
Copyright © 2007, Nortel Networks
.
Create an ingress port-mirror
Delete port-mirroring on a port
Change the mode of the port-mirror
Change the mirrored port
Disable port-mirroring on a port
Change the mirroring port
Display mirrored port information
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
Configuring port mirroring using the CLI 165