No Telnet-Access Command - Nortel 4500 Series Overview-System Configuration

| access | failures | all}] [source-ip <1-50>
<XXX.XXX.XXX.XXX> [mask <XXX.XXX.XXX.XXX>]
Run the telnet-access command in Global Configuration command
mode.
"telnet-access parameters" (page 105)
telnet-access command.
telnet-access parameters
Parameters
enable | disable
login-timeout <1-10>
retry <1-100>
inactive-timeout <0-60>
logging {none | access | failures | all}
[source-ip <1-50>
<XXX.XXX.XXX.XXX> [mask
<XXX.XXX.XXX.XXX>]

no telnet-access command

The no telnet-access command disables the Telnet connection. The
no telnet-access command is accessed through the console serial
connection.
The syntax for the no telnet-access command is
no telnet-access [source-ip [<1-50>]]
Copyright © 2007, Nortel Networks
.
Description
Enable or disable Telnet connection.
Specify in minutes the time for the Telnet connection to be
established after the user connects to the switch. Enter
an integer from 1 to 10.
Specify the number of times the user can enter an
incorrect password before the connection closes. Enter
an integer from 1 to 100.
Specify in minutes the duration before an inactive session
terminates.
Specify the events for which you want to store details in
the event log:
none: Do not save access events in the log.
access: Save only successful access events in the log.
failure: Save failed access events in the log.
all: Save all access events in the log.
Specify the source IP address from which connections can
occur. Enter the IP address in dotted-decimal notation.
Mask specifies the subnet mask from which connections
can occur; enter IP mask in dotted-decimal notation.
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
Setting Telnet access 105
describes the parameters for the
Nortel Networks Confidential