4.
Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
5.
Move the DC circuit breaker on the DC power supply faceplate to the off (O) position.
6.
Remove the clear plastic cover protecting the terminal studs on the faceplate (see
7.
Remove the screw from each of the terminals. (Use a number 2 Phillips screwdriver.)
8.
Remove the cable lugs from the terminals.
9.
Carefully move the power cables out of the way.
10. Press the latch located on the left side of the power supply, to release it from the chassis.
144
Figure
15).