Brake Cable Installation (continued)
RWD Traction Cable Replacement
RWD Traction Cable Removal
Controls: Service and Repairs
g352637
8. Models equipped with electric start only, connect the battery by installing
the positive cable first, then the negative cable to the battery. Install the foam
pad and battery cover. Secure the battery cover with 2 (M4.2 x 2.0) screws.
Torque the screws to 2.26 ± 0.34 N • m (20 ± 3 in-lbs).
9. Models equipped with the 60v powerhead, install the harness to the
powerhead.
1. Park the machine on a level surface, stop the engine and wait for all moving
parts to stop.
2. Models equipped with the 60v powerhead, remove the harness from
powerhead.
3. Models equipped with electric start only, remove the 2 (M4.2 x 2.0)
screws securing the battery cover. Remove the battery cover and foam pad.
Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
4. Remove the grass bagger assembly if attached.
5. Using a 3/8 inch wrench, remove the lock nut and curved washer from the
cable anchor.
Figure 20
Page 5–8
22 Inch AWD/RWD Steel Deck Walk Power
Mower Service Manual
3445-579 Rev A