RWD Front Wheel Installation (continued)
AWD Front Wheel Replacement
AWD Front Wheel Removal
22 Inch AWD/RWD Steel Deck Walk Power Mower Service
Manual
3445-579 Rev A
g352036
1.
Washer
2.
Front Pivot Arm
2. Models equipped with electric start only, connect the battery by installing
the positive cable first, then the negative cable to the battery. Install the foam
pad and battery cover. Secure the battery cover with 2 (M4.2 x 2.0) screws.
Torque the screws to 2.26 ± 0.34 N • m (20 ± 3 in-lbs).
3. Models equipped with the 60v powerhead, install the harness to the
powerhead.
1. Park the machine on a level surface, stop the engine and wait for all moving
parts to stop.
2. Models equipped with the 60v powerhead, remove the harness from
powerhead.
3. Models equipped with electric start only, remove the 2 (M4.2 x 2.0)
screws securing the battery cover. Remove the battery cover and foam pad.
Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
4. Remove the grass bagger assembly if attached.
5. Using 1/2 inch socket wrench, remove the (3/8–16 inch) shoulder bolt
securing the LH wheel to the LH pivot arm. Repeat on the RH side of the unit.
6. Remove the LH wheel and LH gear cover. Repeat on the RH side of the unit.
7. Using a snap ring pliers, remove the snap ring securing the LH pinion gear to
the LH transmission axle shaft. Repeat on the RH side of the unit.
Figure 130
3.
Idler Wheel
4.
Wheel Bolt
Page 7–7
Drive System: Service and Repairs