AWD Front Wheel Installation (continued)
22 Inch AWD/RWD Steel Deck Walk Power Mower Service
Manual
3445-579 Rev A
g359882
3. Install the snap ring securing the pinion gear to the LH transmission axle
shaft. Repeat on the RH side of the unit.
g359881
4. Install the LH wheel to the LH pivot arm, secure with the (3/8–16 inch)
shoulder bolt. Torque the bolt to 35 ± 1.69 N • m (315 ± 15 in-lb). Repeat
on the RH side of the unit.
5. Models equipped with electric start only, connect the battery by installing
the positive cable first, then the negative cable to the battery. Install the foam
pad and battery cover. Secure the battery cover with 2 (M4.2 x 2.0) screws.
Torque the screws to 2.26 ± 0.34 N • m (20 ± 3 in-lbs).
6. Models equipped with the 60v powerhead, install the harness to the
powerhead.
Figure 133
Figure 134
Page 7–9
Drive System: Service and Repairs