RWD Front Height-of-Cut Installation (continued)
Deck: Service and Repairs
g352391
2. Install the mount bushing, spring arm, and the front pivot arm to the LH
height-of-cut plate and secure with the (5/16–18 inch) screw, flat washer,
and nut. Torque the nuts to 19.2 ± 3.39 N • m (170 ± 30 in-lb). Repeat on
the RH side of the unit.
g352409
3. Install the front non-drive wheels.
4. Models equipped with electric start only, connect the battery by installing
the positive cable first, then the negative cable to the battery. Install the foam
pad and battery cover. Secure the battery cover with 2 (M4.2 x 2.0) screws.
Torque the screws to 2.26 ± 0.34 N • m (20 ± 3 in-lbs).
5. Models equipped with the 60v powerhead, install the harness to the
powerhead.
Figure 99
Figure 100
RWD Front Wheel Installation (page 7–6)
Page 6–10
22 Inch AWD/RWD Steel Deck Walk Power
Mower Service Manual
3445-579 Rev A