Awd Front Height-Of-Cut Replacement - Toro 21462 Service Manual

AWD Front Height-of-Cut Replacement

AWD Front Height-of-Cut Removal
AWD Front Height-of-Cut Installation
22 Inch AWD/RWD Steel Deck Walk Power Mower Service
Manual
3445-579 Rev A
1. Park the machine on a level surface, stop the engine and wait for all moving
parts to stop.
2. Remove the grass bagger assembly if attached.
3. Remove the AWD front wheels.
4. Remove the large snap ring from the LH bushing retainer. Repeat on the RH
side of the unit.
5. Remove the LH pivot arm and spring arm from the transmission. Repeat
on the RH side of the unit.
6. Remove the 2 (½ inch) screws securing the LH AWD front height-of-cut plate
to the deck. Repeat on the RH side of the unit.
g360548
7. Remove the LH AWD front height-of-cut plate. Repeat on the RH side of
the unit.
1. Install the LH AWD front height-of-cut plate, secure with 2 (½ inch) screws.
Repeat on the RH side of the unit.
AWD Front Wheel Removal (page 7–7)
Figure 101
Page 6–11 Deck: Service and Repairs