Upper Intake Replacement - Toro 21462 Service Manual

Rear Height-of-Cut Installation (continued)

Upper Intake Replacement

Upper Intake Removal
Deck: Service and Repairs
g361220
5. Install the rear wheels.
6. Models equipped with electric start only, connect the battery by installing
the positive cable first, then the negative cable to the battery. Install the foam
pad and battery cover. Secure the battery cover with 2 (M4.2 x 2.0) screws.
Torque the screws to 2.26 ± 0.34 N • m (20 ± 3 in-lbs).
7. Models equipped with the 60v powerhead, install the harness to the
powerhead.
1. Park the machine on a level surface, stop the engine and wait for all moving
parts to stop.
2. Models equipped with the 60v powerhead, remove the harness from
powerhead.
3. Models equipped with electric start only, remove the 2 (M4.2 x 2.0)
screws securing the battery cover. Remove the battery cover and foam pad.
Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
4. Remove the grass bagger assembly if attached.
5. Tip the unit to gain access to the underside of the unit.
6. Position the blade out of the way of the lower intake.
7. Remove the (1/4 x 1.33 inch) shoulder screw securing the bottom intake
cover to the deck.
8. Remove the bottom intake from the deck.
9. Remove the 2 (1/4 x 1.33 inch) screws securing the upper intake to the deck.
Figure 113
Rear Wheel Installation (page 7–11)
Page 6–18 22 Inch AWD/RWD Steel Deck Walk Power
Mower Service Manual
3445-579 Rev A