Awd Rear Transmission Replacement - Toro 21462 Service Manual

RWD Transmission Removal (continued)
RWD Transmission Installation

AWD Rear Transmission Replacement

AWD Rear Transmission Removal
Drive System: Service and Repairs
6. Remove the rear height-of-cut assemblies.
(page 6–12)
7. Remove the belt from the engine pulley.
8. Remove the transmission and transmission belt.
1. Install the transmission and transmission belt.
2. Install the belt onto the engine pulley.
3. Install the rear height-of-cut assemblies.
(page 6–16)
4. Install the traction cable.
5. Models equipped with electric start only, connect the battery by installing
the positive cable first, then the negative cable to the battery. Install the foam
pad and battery cover. Secure the battery cover with 2 (M4.2 x 2.0) screws.
Torque the screws to 2.26 ± 0.34 N • m (20 ± 3 in-lbs).
6. Models equipped with the 60v powerhead, install the harness to the
powerhead.
1. Park the machine on a level surface, stop the engine and wait for all moving
parts to stop.
2. Models equipped with the 60v powerhead, remove the harness from
powerhead.
3. Models equipped with electric start only, remove the 2 (M4.2 x 2.0)
screws securing the battery cover. Remove the battery cover and foam pad.
Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
4. Remove the grass bagger assembly if attached.
5. Remove the AWD rear traction cable.
(page 5–16)
6. Remove the brake cable.
7. Remove the blade from the engine crank. Refer to the product Operator's
Manual for the blade removal procedures.
8. Remove the 2 (1/4–10 inch) LH screws securing the rear baffle to the deck.
Repeat on the RH side of the unit.
Rear Height-of-Cut Installation
RWD Traction Cable Installation (page 5–11)
AWD Rear Traction Cable Removal
Brake Cable Removal (page 5–4)
Page 7–12 22 Inch AWD/RWD Steel Deck Walk Power
Rear Height-of-Cut Removal
Mower Service Manual
3445-579 Rev A