Deck Replacement - Toro 21462 Service Manual

Chute Assembly Installation (continued)

Deck Replacement

Deck Removal
Deck: Service and Repairs
g352575
5. Install the rear back door onto the unit.
6. Install the rear height-of-cut plates.
7. Models equipped with electric start only, connect the battery by installing
the positive cable first, then the negative cable to the battery. Install the foam
pad and battery cover. Secure the battery cover with 2 (M4.2 x 2.0) screws.
Torque the screws to 2.26 ± 0.34 N • m (20 ± 3 in-lbs).
8. Models equipped with the 60v powerhead, install the harness to the
powerhead.
1. Park the machine on a level surface, stop the engine and wait for all moving
parts to stop.
2. Models equipped with the 60v powerhead, remove the harness from
powerhead.
3. Models equipped with electric start only, remove the 2 (M4.2 x 2.0)
screws securing the battery cover. Remove the battery cover and foam pad.
Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
4. Remove the grass bagger assembly if attached.
5. RWD models only, remove the RWD traction cable.
Removal (page 5–8)
6. AWD models only, remove the AWD front and rear traction cables.
Front Traction Cable Removal (page 5–14) AWD Rear Traction Cable
Removal (page 5–16)
7. Remove the brake cable.
8. Remove the LH handle knob from the curved handle. Repeat on the RH
side of the unit.
9. Remove the curved handle from the chassis.
(Non—Electric Start Models Only) (page 5–37) Curved Handle Removal
(Electric Start Models Only) (page 5–40)
Figure 123
Rear Height-of-Cut Removal (page 6–12)
Brake Cable Removal (page 5–4)
Page 6–24 22 Inch AWD/RWD Steel Deck Walk Power
RWD Traction Cable
AWD
Curved Handle Removal
Mower Service Manual
3445-579 Rev A