Engine/Powerhead Replacement
Engine/Powerhead Removal
22 Inch AWD/RWD Steel Deck Walk Power Mower Service
Manual
3445-579 Rev A
1. Park the machine on a level surface, stop the engine and wait for all moving
parts to stop.
2. Models equipped with the 60v powerhead, remove the harness from
powerhead.
3. Models equipped with electric start only, remove the 2 (M4.2 x 2.0)
screws securing the battery cover. Remove the battery cover and foam pad.
Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
4. Remove the grass bagger assembly, if attached.
5. Remove the brake cable from the engine.
6. Remove the blade the from the engine crank. Refer to the product Operator's
Manual for the blade removal procedures.
7. Relieve the belt tension by rocking the transmission forward and removing
the belt from the blade drive.
8. Remove the blade driver from the crank.
g352011
9. Remove the (1/4 x 1.33 inch) shoulder screw securing the bottom intake
cover to the deck.
Brake Cable Removal (page 5–4)
Figure 5
Page 4–5
Power Source: Service and Repairs