Rwd Transmission Replacement - Toro 21462 Service Manual

Rear Wheel Removal (continued)
Rear Wheel Installation

RWD Transmission Replacement

RWD Transmission Removal
22 Inch AWD/RWD Steel Deck Walk Power Mower Service
Manual
3445-579 Rev A
7. Remove the pinion gear, thrust washer, and rear pivot from the LH
transmission axle shaft. Repeat on the RH side of the unit.
1. Install the rear pivot, thrust washer, and pinion gear onto the LH transmission
axle shaft. Repeat on the RH side of the unit.
2. Install the snap ring onto the LH transmission axle shaft. Repeat on the RH
side of the unit.
3. Install the gear cover and wheel to the LH pivot arm, secure with the (3/8–16
inch) wheel bolt. Torque the bolt to 35 ± 1.69 N • m (315 ± 15 in-lb). Repeat
on the RH side of the unit.
g352317
4. Models equipped with electric start only, connect the battery by installing
the positive cable first, then the negative cable to the battery. Install the foam
pad and battery cover. Secure the battery cover with 2 (M4.2 x 2.0) screws.
Torque the screws to 2.26 ± 0.34 N • m (20 ± 3 in-lbs).
5. Models equipped with the 60v powerhead, install the harness to the
powerhead.
1. Park the machine on a level surface, stop the engine and wait for all moving
parts to stop.
2. Models equipped with the 60v powerhead, remove the harness from
powerhead.
3. Models equipped with electric start only, remove the 2 (M4.2 x 2.0)
screws securing the battery cover. Remove the battery cover and foam pad.
Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
4. Remove the grass bagger assembly if attached.
5. Remove the traction cable.
Figure 137
RWD Traction Cable Removal (page 5–8)
Page 7–11 Drive System: Service and Repairs