Rear Wheel Drive Solenoid Replacement
Figure 11
1. Disconnect solenoid electrical connector.
2. Remove nut from solenoid.
3. Remove solenoid coil.
4. Install new solenoid coil. Make sure o–ring is installed
at each end of coil. Apply "Loctite 242" or equivalent to
threads on end of valve stem before installing nut. Tight-
en nut to a torque of 15 in–lb. Over–tightening may dam-
age the solenoid or cause the valve to malfunction.
5. Connect wiring connector.
Figure 12
Reelmaster 4500–D
Electrical System
Page 5 – 25