Hydrostatic Drive Belt Installation (continued)
Hydrostatic Drive Transmission Replacement
Hydrostatic Drive Transmission Removal
2000 Series Z MASTER® Service Manual
3438-778 Rev A
8. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
1. Stop the engine, wait for all moving parts to stop, and remove the key.
Engage the parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the left and right consoles.
Right Console Replacement (page 5–13)
4. Remove the seat.
5. Remove the fuel tank.
6. Raise and support the unit so that the drive wheels are off the ground.
7. Remove the drive wheel(s).
8. Remove the mower belt.
9. Remove the drive belt.
10. Disconnect the motion control linkage from the transmission.
11. Disconnect the bypass arm.
g336196
12. Disconnect the lower brake linkage from the transmission.
Left Console Replacement (page 5–11)
Seat Replacement (page 5–15)
Fuel Tank Replacement (page 5–16)
Mower Belt Replacement (page 6–6)
Hydrostatic Drive Belt Replacement (page 7–8)
Figure 74
Page 7–9
Drive System: Service and Repairs