Mower Deck Replacement - Toro TITAN Service Manual

Mower Belt Installation (continued)

Mower Deck Replacement

Mower Deck Removal
Mower Deck Installation
Titan Service Manual
3438-774 Rev A
4. Install the belt covers. Torque the belt cover bolts to 6–8 N • m (50–75 in-lb).
5. Tighten the bolts to secure the cover to the deck.
6. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
1. Park the machine on a level surface and disengage the PTO. Stop the engine,
wait for all moving parts to stop, and remove key. Engage the parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the height adjustment pin and lower the deck to the ground.
4. Remove the mower belt.
5. Remove the 2 hairpins and washers that secure the link pin to the frame
and deck, then remove the link pin.
g322064
1. Link Pin
2. Hairpin Cotter
6. Lift the mower deck to remove tension from the chains and unhook the
chains from the deck lift arms.
7. Raise the height-of-cut to the transport position.
8. Slide the deck out from underneath the machine.
1. Place the deck on the ground and slide it into position underneath the
machine.
2. Lower the height-of-cut into the lowest position and secure with the
height-of-cut pin.
3. Lift the rear of the mower deck and attach the chains to the rear lift arms.
4. Attach the front chains to the front deck lift arms.
Figure 78
3. Washer
Page 7–7 Mower Deck: Service and Repairs