Omron F3SG-PGA-A User Manual page 374

Wiring and Installation
2.
Slide the Top/Bottom Bracket (1) in the grooves of the sensor housing. Adjust the Top/Bottom Bracket
to the mounting position of the wall surface. Make sure to contact the whole body of the Top/Bottom
Bracket (1) with the groove of the yellow area of the housing. Securely tighten the Mounting Screws to
fix the Top/Bottom Bracket to the housing of the sensor. The recommended torque to tighten the
Mounting Screws of the Top/Bottom Bracket is 3.0 N•m. (Fig. 2)
Tightening screws with a torque that considerably exceeds the recommended torque may cause failure.
3.
Securely tighten screws to fix the Adjustable Side-Mount Bracket to the mounting position of the wall
surface. When using more than one Adjustable Side-Mount Brackets, align them in the same line using
the sides of the brackets that do not face the wall, before attaching the brackets to the sensor. (Fig. 3)
M5/M6
Screws to mount the brackets to the wall are not included.
F3SG-SR/PG
344
User's Manual
<Backside mounting>
Slide into the backside
of the housing
Mounting Screw
Securely tighten
<Backside mounting> <Side mounting>
<Side mounting>
Mounting Screw
Securely tighten
Fig. 2
Align in the
same line
M5/M6
Fig. 3
Slide into the backside
of the housing