10.
Turn on power of the intelligent tap and F3SG-SR/PG.
11.
Check that F3SG-SR/PG runs as intended.
If it does not, turn off power of the intelligent tap and F3SG-SR/PG, make sure that the wiring is proper,
and go back to step 4. to perform the steps again.
12.
Turn off power of the intelligent tap and F3SG-SR/PG.
To finish the maintenance task and start normal operation of the facility,
perform the followings.
1.
Use a Phillips screwdriver to attach the cover of the intelligent tap.
(Recommended tightening torque: 0.35Nm)
2.
If a cable is not attached to CN3, use the torque wrench XY2F-0004 to attach the accessory
waterproof cover (for plug).
(Recommended tightening torque for waterproof cover (for plug): 0.39 to 0.49Nm)
3.
If a cable is not attached to CN4, attach the accessory waterproof cover (for socket).
Setting with Intelligent Tap
F3SG-SR/PG
User's Manual
E
195