Omron F3SG-PGA-A User Manual page 212

Setting with Intelligent Tap
Index
70
71
(Primary
sensor
Receiver)
72
(Secondary
sensor 1
Receiver)
73
(Secondary
sensor 2
Receiver)
80
*1. Defining the receiving light intensity level that turns ON the control output as 100%, the output is 22. Therefore, if the level is
170% and 90%, the output is 38 and 20, respectively.
F3SG-SR/PG
182
User's Manual
Sub-Index Name
1 Synchronization
method setting
2 External device
monitor setting
3 Interlock / Pre-
Reset / PSDI
setting
4 Blanking setting
5 PNP / NPN setting
6 Dip switch setting
7 Muting status
8 Override status
9 Muting sequence
error status
10 Safety output status
11 Blanking bream
unblocked
information
12 Push switch status
0 Receiving light level
0 Receiving light level
0 Receiving light level
0 Error code of
Intelligent Tap
R/W Length
R 1 byte 0: Optical sync. Scan code A
1: Optical sync. Scan code B
2: Wired sync.
3: Reserved.
R 1 byte 1: Enable , 0: Disable
R 1 byte 0: Auto reset (both start and re-start interlock are disabled)
1: Start interlock is enabled.
2: Re-start interlock is enabled.
3: Manual reset (both start and re-start interlock are
enabled)
4: Pre-Reset is enabled.
5: PSDI single break
6: PSDI double break
The others: Reserved.
R 1 byte 1: One of Fixed Blanking or Floating Blanking and Warning
zone setting is enabled.
0: Fixed Blanking, Floating Blanking and Warning zone
setting are disabled.
R 1 byte 1: PNP setting
0: NPN setting
R 1 byte 1: Enable
0: Disable (setting is done by Tool)
R 1 byte 1: Under the MUTING state
0: The other
R 1 byte 1: Under the OVERRIDE state
0: The other
R 1 byte 1: Muting setting is active and sequence error occurs.
0: The other
R 1 byte 1: ON
0: OFF
R 1 byte 1: When Fixed-Blanking or Floating Blanking beams are
unblocked
0: The other
R 1 byte 1: ON
0: OFF
R 232 bytes 1byte x 232 beams
The incident light level data of each beam is output in 0 to
255 (8 bits) every beam (1 byte). *1
0 if the sensor is not connected or no light is received
R 232 bytes 1byte x 232 beams
The incident light level data of each beam is output in 0 to
255 (8 bits) every beam (1 byte). *1
0 if the sensor is not connected or no light is received
R 232 bytes 1byte x 232 beams
The incident light level data of each beam is output in 0 to
255 (8 bits) every beam (1 byte). *1
0 if the sensor is not connected or no light is received
R 48 bytes Error code data is output in 8 bytes.
(8 bytes In order from upper to lower
x 6) 1 byte: Error code
4 bytes: Power-ON Time (1 count every 15 minutes)
3 bytes: Data for inquiry*
Latest 6 records can be got.
* Please use the data for your inquiry.
Setting contents