ACX2200 Universal Access Router Hardware Guide
Related
Documentation
Console/Auxiliary Port Connector Pinout on ACX Series Routers
Related
Documentation
USB Port Specifications for an ACX Series Router
56
Table 24: Management Port Connector Pinout Information (continued)
Pin
Description
8
TRD[3]+
Console/Auxiliary Port Connector Pinout on ACX Series Routers on page 56
The port on the front panel labeled
that accept an RJ-45 connector. Use a cable with the pinouts described in
Table 25 on page 56
to connect the Routing Engine to an auxiliary or console management
device.
NOTE:
You must use a shielded twisted pair (STP) cable for both outdoor
and indoor deployments.
Table 25: Connector Pinout for the Console/Auxiliary Port
Pin
Signal
1
RTS
2
TXD
3
TXD
4
Ground
5
Ground
6
RXD
7
RXD
8
CTS
Management Port Connector Pinout Information for ACX Series Routers on page 55
The following Juniper Networks USB flash drives have been tested and are officially
supported for the USB port on all ACX Series routers:
RE-USB-1G-S
Direction
In/Out
is an asynchronous serial interface
CONSOLE/AUX
Description
CPU
Request to Send
Routing Engine
Transmit Data
1588 CPU
Transmit Data
Routing Engine
Signal Ground
–
Signal Ground
–
Receive Data
Routing Engine
Receive Data
1588 CPU
Clear to Send
Routing Engine
Copyright © 2017, Juniper Networks, Inc.
Direction
Out
Out
Out
–
–
In
In
In