Console Port Connector Pinout On Acx7100 Routers - Juniper ACX7100-32C Hardware Manual

The port uses an autosensing RJ-45 connector to support a 10/100BASE-T connection.
Table 27 on page 56 provides the pinout information for the RJ-45 connector for the management
port.
Table 27: Management Port Connector Pinout Information
Pin Description
1 TRP1+
2 TRP1–
3 TRP2+
4 TRP3+
5 TRP3–
6 TRP2–
7 TRP4+
8 TRP4–

Console Port Connector Pinout on ACX7100 Routers

The port labeled CON on the front panel is an RS-232 serial interface that uses an RJ-45 connector to
connect to a console management device. The default baud rate for the console port is 9600 baud.
Use a cable with the pinouts described in
management device.
NOTE: If your laptop or PC does not have a DB-9 plug connector pin and you want to connect
your laptop or PC directly to an ACX7100, use a combination of the RJ-45 cable and RJ-45 to
Direction
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
Transmit/receive data pair 4
Transmit/receive data pair 4
Table 28 on page 57 to connect an ACX7100 to a console
56