Replacing Right Sealing Ring - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Lightly oil new gasket ring at outside diameter and drive in with
pressure plate - T10049- up to the stop, do not twist the gasket
ring.
– Fill half the space between the sealing lip and dust lip with
sealing grease - G 052 128 A1- .
– Clamp the flange shaft in a vice with protective jaws.
– Push out the old circlip from the flange shaft groove with the
new circlip -A-.
– Drive in the flange shaft with a rubber hammer.
– Install drive shaft ⇒ Chassis; Rep. gr. 42 .
– Checking the oil level in the rear final drive
⇒ "5.2 Check the oil level in the final drive.", page 90
4.2

Replacing right sealing ring

Special tools and workshop equipment required
♦ Ejection lever - MP3-418 (VW 681)-
♦ Extractor - T10037-
♦ Pressure spindle - T10049-
♦ Catch pan
♦ Sealing grease - G 052 128 A1-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
– Remove drive shaft ⇒ Chassis; Rep. gr. 42
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Place a catch pan under the rear final drive.
– Manually screw the plate of the extractor - T10037- with two
screws M8 (30 mm long) onto the flange shaft.
• The shoulders for larger flange diameters point to the outside.
– Fit the nut of the knurled screw -arrow- of the extractor -
T10037- in such a way that the start of the thread is aligned
with the housing.
– Pull out the flange shaft with extractor - T10037- .
84
Rep. gr.39 - Final drive - rear differential
.