Skoda Octavia II 2004 Workshop Manual page 130

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
• Rear final drive is installed.
Removing
– Remove propshaft from rear final drive
⇒ "1.2 Removing and installing propshaft from rear final drive",
page 21 .
– Disconnect plug -B- from four-wheel drive control unit - J492-
-A-.
• Do not disconnect plug connection -C-.
– Place used oil collector and extractor - V.A.G 1782- under the
four-wheel drive clutch.
– Unscrew drain plug -arrow- and drain all oil from the four-wheel
drive clutch.
– Screw in new drain plug -arrow- with a new gasket ring.
– Unscrew fixing screws -arrows- and pull four-wheel drive
clutch out of the rear final drive.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Replace O-Ring -arrow- for four-wheel drive clutch.
• Coat new O-ring with high-performance oil for four-wheel drive
clutch before inserting.
126
Rep. gr.39 - Final drive - rear differential