Skoda Octavia II 2004 Workshop Manual page 79

– Bring the final drive into the indicated position.
– Raise the final drive and guide the rear bracket -arrows- above
the assembly carrier, during this procedure ensure that there
is adequate free access to the adjoining components.
– Mount the plug connection -A- on the four-wheel drive control
unit - J492- .
– Push the ventilation lines -arrows- onto the ventilation pipes of
the final drive.
– Move the final drive into its installed position using the engine
and gearbox jack - V.A.G 1383 A- .
– Place the washer -C- on the front bracket.
– Tighten screw -B- by hand.
• The rear part of the final drive must be free in order to install
the drive shafts.
– Remove the engine and gearbox jack - V.A.G 1383 A- from
underneath the vehicle.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
75
2. Final drive