Skoda Octavia II 2004 Workshop Manual page 95

⇒ "5.1 Installation location overview - drain plug and check screw",
page 90 .
Check the oil level, drain and fill oil for the four-wheel drive clutch
⇒ "6 Four-wheel drive clutch", page 92
Checking
• Vehicle on level ground.
• Oil for rear final drive ⇒ Electronic Catalogue of Original Parts .
– Place catch pan under the final drive.
– Unscrew screw for oil inspection -2-.
• Oil is at the correct level if the rear final drive is filled with oil
up to the lower edge of the oil filler hole.
– Screw in and tighten new screw for oil inspection -2-.
Refilling
– Screw the adapter for filling device - VAS 6291- into the hole
of the inspection plug for axle oil on the final drive -2-.
– Top up oil into the final drive using the filling device - VAS
6291- , until oil flows out between the adapter and the final
drive housing.
– Remove filling device - VAS 6291- ; some excess oil may still
flow out.
• Oil is at the correct level if the rear final drive is filled with oil
up to the lower edge of the oil filler hole.
– Screw in new screw for oil inspection -2-.
Tightening torques
♦ Oil drain plug and check screw for final drive
⇒ "5.1 Installation location overview - drain plug and check
screw", page 90 .
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
91
5. Axle oil in final drive