Sealing Rings; Replacing Left Sealing Ring - Skoda Octavia II 2004 Workshop Manual

4

Sealing rings

⇒ "4.1 Replacing left sealing ring", page 83
⇒ "4.2 Replacing right sealing ring", page 84
⇒ "4.3 Replacing gasket ring for output flange of the rear final
drive", page 85
4.1

Replacing left sealing ring

Special tools and workshop equipment required
♦ Ejection lever - MP3-418 (VW 681)-
♦ Extractor - T10037-
♦ Pressure spindle - T10049-
♦ Catch pan
♦ Sealing grease - G 052 128 A1-
Removing
– Remove drive shaft ⇒ Chassis; Rep. gr. 42
– Place a catch pan under the rear final drive.
– Manually screw the plate -1- of the extractor - T10037- with
two screws M8 (30 mm long) onto the flange shaft.
• The shoulders -arrows- for larger flange diameters point to the
outside.
– Position the nut of the knurled screw -2- from the extractor -
T10037- onto the hexagon screw -3-.
– Pull out the flange shaft with extractor - T10037- .
– Pull out gasket ring for flange shaft with ejection lever -
MP3-418- .
Installing
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
83
4. Sealing rings