Replacing The Sealing Ring For The Outer Drive Shaft - Skoda Fabia II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
2.4 Replacing the sealing ring for the outer
drive shaft
Special tools and workshop equipment required
♦ Pipe section - MP3-450 (VW 415A)-
♦ Extractor tool - T20143-
2 shaft seals are located in the gearbox -arrows- on the clutch
side. Both seals can be replaced without disassembling the gear‐
box. If only the shaft seals are replaced, the double clutch must
not be adjusted.
In the event of a gearbox drive shaft "Leaks" error, the condition
of the engine crankshaft sealing flange on the gearbox side must
also be checked.
• Double clutch gearbox removed
⇒ "2.2 Remove double clutch", page 66
• Clutch release mechanism is removed
⇒ "1.2 Removing and installing clutch release mechanism",
page 34
Caution
If there are leaks, you must check the double clutch. If the
double clutch is covered in oil, it will need to be replaced.
– Lever out shaft seal for outer drive shaft.
74
Rep. gr.30 - Clutch