Skoda Octavia II 2004 Workshop Manual page 21

1 - Angle gearbox
2 - Screw
❑ Replace after disas‐
sembly
❑ 50 Nm + 90°
3 - Flexible disk
❑ Fitting position: the
open side of the flexible
disk faces towards the
gearbox.
4 - Screw
❑ 60 Nm
5 - Front propshaft pipe
❑ when installing and re‐
moving do not damage
the centering bushing
and gasket ring in the
middle of the flange
6 - Screw
❑ 40 Nm
7 - Thrust plate
8 - Clamp
❑ tensioning ⇒ page 44
9 - Boot for constant velocity
joint
❑ drive out with drift pin
before pressing off the
CV joint
❑ check for damage
10 - Disc spring
❑ interlocked at inside di‐
ameter
❑ Fitting position: large diameter lies on the CV joint
11 - Gasket
❑ Replace after each disassembly (remove the protective foil and stick it to the joint)
12 - CV joint
❑ pressing off ⇒ page 43
❑ inserting ⇒ page 43
❑ Filling grease: push 25 g grease on each side (total 50 g) into the joint. Grease joint if necessary, when
replacing the joint boot
13 - Circlip
❑ Replace after disassembly
❑ removing and installing with circlip pliers
14 - Screw
❑ 45 Nm
15 - Thrust plate
❑ Replace after disassembly
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
16 - Flange
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
❑ removing ⇒ page 44
❑ installing ⇒ page 44
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
17
1. Propshaft