Skoda Octavia II 2004 Workshop Manual page 31

– After removing the heat shield screw on again by hand the
intermediate bearing of the propshaft -arrow- with the screws
-1-.
– Unscrew propshaft from angle gearbox -arrows-.
When loosening and tightening, counterhold the propshaft on the
rear final drive.
– Unscrew screws arrow -B- and arrow -C- of the pendulum
support.
Note
After unscrewing the fixing screw of the pendulum support at the
gearbox, the engine/gearbox unit is slided ahead somewhat.
Make sure that the gasket in the cardan shaft flange is not dam‐
aged.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
27
1. Propshaft