Skoda Octavia II 2004 Workshop Manual page 29

– Fit propshaft to rear final drive such that the markings
-arrows- are in one plane.
– Screw on screws -arrows- of the connections of the propshaft/
rear final drive and tighten.
– Align guide bearing in elongated holes so that propshaft and
guide bearing are free of stress.
– Tighten screws -arrows-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
– Install the pendulum support ⇒ Rep. gr. 10 ; Assembly mount‐
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
ings; removing and installing the pendulum support . with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Install protection plate for propshaft.
– Install the rear silencers ⇒ Rep. gr. 26 ; Exhaust pipes/si‐
lencers .
– Install the tunnel bridge ⇒ General body repairs, exterior; Rep.
gr. 66 ; Underfloor trim panel; installing and removing and
installing tunnel bridge .
– Install the noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Summary of components -
noise insulation .
Tightening torques - summaries of components
Note
Replace bolts / nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
⇒ "1.1 Summary of components - propeller shaft", page 16
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
25
1. Propshaft