Skoda Octavia II 2004 Workshop Manual page 99

11 - Oil filter
❑ for four-wheel drive clutch
❑ Removing and installing
12 - Spring
13 - Housing for four-wheel drive clutch
❑ Removing and installing complete four-wheel drive clutch
⇒ "6.8.1 Removing and installing generation II four-wheel drive clutch, final drive 02D, 0AV, Octavia II",
page 115
14 - Nut
❑ Replace after disassembly
❑ secure with locking agent - D 000 600-
❑ 210 Nm
15 - Propshaft flange
❑ Removing and installing
16 - Gasket ring for propshaft flange
❑ Replace after disassembly
❑ Replace ⇒ "4.3 Replacing gasket ring for output flange of the rear final drive", page 85
17 - Circlip
18 - Grooved ball bearing
❑ Removing and installing
⇒ "6.9.1 Replacing generation II four-wheel drive clutch grooved ball bearing, final drive 02D, 0AV, Oc‐
tavia II", page 128
19 - Four-wheel drive control unit - J492-
❑ with control valve of opening degree of coupling - N373-
❑ with oil level and oil temperature sender - G437-
❑ Removing and installing
⇒ "6.10.1 Removing and installing generation II four-wheel drive clutch control unit, final drive 02D, 0AV,
Octavia II", page 134
20 - Screw
❑ 6 Nm
21 - O-ring
❑ Replace after disassembly
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
❑ coat with oil for four-wheel drive clutch before inserting
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
⇒ "6.6 removing and installing oil filter", page 109
⇒ "4.3 Replacing gasket ring for output flange of the rear final drive", page 85
Propshaft and rear final drive - Edition 10.2018
95
6. Four-wheel drive clutch