Disassembling And Assembling Coupling - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
6.9 Disassembling and assembling cou‐
pling
⇒ "6.9.1 Replacing generation II four-wheel drive clutch grooved
ball bearing, final drive 02D, 0AV, Octavia II", page 128
6.9.1 Replacing generation II four-wheel drive
clutch grooved ball bearing, final drive
02D, 0AV, Octavia II
Special tools and workshop equipment required
♦ Counterholder - T10172-
♦ Adapter - T10172/5-
♦ Engine and gearbox jack - V.A.G 1383 A-
♦ Tensioning strap - T10038-
♦ Rig tool - T30004 (3415)-
♦ Three-arm extractor e. g. -VAS 251 201- or -Kukko 12-1-
♦ Ejection lever - MP3-418 (VW 681)-
♦ Two-arm extractor e. g. -VAS 251 001- or -Kukko 20-10-
♦ Pressure plate - MP3-407 (VW 402)-
♦ Pressure spindle - MP3-408 (VW 412)-
♦ Pipe - T30034 (41 - 501)-
♦ Pressure spindle - T30055 (3296)-
♦ Assembly tool - T10030-
♦ Pressure spindle - T10019-
♦ Pipe - MP3-409 (VW 418 A)-
♦ Thrust piece - MP3-411 (VW 454)-
♦ Thrust piece - MP3-453 (VW 431)-
♦
♦ Locking agent - D 000 600-
♦ Catch pan
♦ Allan screw M8 x 15
♦ Screw M10 x 25
Removing
– Raise vehicle.
NOTICE
Risk of damage to the decoupling element of the exhaust sys‐
tem.
The decoupling element must not be bent or kinked by more
than 10°.
– Do not load the decoupling element with tensile stress.
– Do not bend the decoupling element excessively.
128
Rep. gr.39 - Final drive - rear differential
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.