Skoda Octavia II 2004 Workshop Manual page 142

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Release screws -arrows-.
• Ensure that no parts fall down when removing the control unit.
– Carefully remove the control unit -A-.
– If necessary remove the cover
housing of the four-wheel drive clutch, while doing so hold the
valve -arrow-.
– Cover the control valve for opening degree of coupling - N373-
-arrow- with a cloth. Carefully grip the valve body -arrow- with
pliers and pull out the valve.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Replace gasket rings -1...4- ⇒ Electronic Catalogue of Origi‐
nal Parts .
Note
The valve gasket rings have different inner diameters.
♦ Inside diameter of gasket ring -1- is 10 mm
♦ Inside diameter of gasket ring -2- is 11 mm
♦ Inside diameter of gasket ring -3- is 12 mm
♦ Gasket ring at valve body -4-
138
Rep. gr.39 - Final drive - rear differential
⇒ Item 3 (page 104) from the
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.