Skoda Octavia II 2004 Workshop Manual page 81

– Tighten the lower screw -arrow-.
– Install propshaft on final drive and tighten.
– Tighten the drive shafts.
– Install new screws -B- and -C- on the pendulum support and
tighten.
– Align intermediate bearing free of stress and tighten.
– Install the heat shield below the propshaft.
– Install rear left vehicle level sensor - G76- ⇒ Chassis; Rep.
gr. 42 .
Carry out a basic setting of the headlights ⇒ Vehicle diagnostic
tester.
– Install exhaust system ⇒ Engine; Rep. gr. 26
If the final drive was replaced:
– Check the oil level in the four-wheel drive clutch, top up with
oil if necessary
⇒ "6.4 Checking oil level in the four-wheel drive clutch",
page 106 .
– Check the oil level in the rear final drive, top up with oil if nec‐
essary ⇒ "5 Axle oil in final drive", page 90
Tightening torques
♦ Propshaft to final drive
⇒ "1.1 Summary of components - propeller shaft", page 16
♦ Intermediate bearing
⇒ "1.1 Summary of components - propeller shaft", page 16
♦ Pendulum support to gearbox ⇒ Engine; Rep. gr. 10
♦ Exhaust System ⇒ Engine; Rep. gr. 26
♦ Final drive to assembly carrier ⇒ Suspension; Rep. gr. 42
♦ Anti-roll bar⇒ Chassis; Rep. gr. 42 .
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
77
2. Final drive