Skoda Octavia II 2004 Workshop Manual page 116

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Replace O-rings -1- and -2-.
– Coat O-rings -1- and -2- thinly with high-performance oil for
four-wheel drive clutch .
– Fill oil for four-wheel drive clutch
⇒ "6.5 Drain off and fill oil for four-wheel drive clutch",
page 107 .
Tightening torques
♦ Rear final drive to assembly carrier ⇒ Chassis; Rep. gr. 42
♦ Pump to four-wheel drive clutch
⇒ "6.1.2 Summary of components - generation II four-wheel
drive clutch, Octavia II", page 94
6.7.2 Removing and installing generation IV
four-wheel drive clutch pump, final drive
0BR, Octavia II, Superb II, Yeti, up to
10/2013
In Yeti vehicles with rear final drive 0BR, generation IV four-wheel
drive clutch was installed up to production date 10/2013. From
production date 11/2013, the generation V four-wheel drive clutch
is installed. Assignment ⇒ Electronic Catalogue of Original Parts
Removing
– Switch off ignition.
– Drain oil from the four-wheel drive clutch
⇒ "6.5 Drain off and fill oil for four-wheel drive clutch",
page 107 .
– Screw in new oil drain plug -A- and tighten.
– Slightly lower the final drive, to do so the fixing screw -arrow-
must be released by approx. 5 turns at the front bracket of the
final drive.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
112
Rep. gr.39 - Final drive - rear differential