Skoda Octavia II 2004 Workshop Manual page 35

Propshaft and rear final drive
Hide thumbs Also See for Octavia II 2004:
Table of Contents

Advertisement

Note
If droning noises occur while driving, the following must be
observed.
Remove balancing nut and balancing washer -arrows-.
Then unscrew if necessary the propshaft with the flexible disk
from the flange of the four-wheel drive clutch and screw on
again offset by one hole.
If the droning noises can still be heard, the propshaft must be
screwed on once again offset to a hole.
Tightening torques
⇒ "1.1.1 Summary of components - propshaft, Octavia II up to
05/2007", page 16
1.3.2
Removing and installing propshaft, Oc‐
tavia II as of 06/2007
Special tools and workshop equipment required
♦ Engine/gearbox jack , e.g. -V.A.G 1383A-
♦ Thread repair set , e. g. -VAS 6024-
♦ Counterholder - T10172-
♦ Adapter - T10172/5-
One-part propshaft installed from 28/05/2007. The front propshaft
pipe can be separated from rear propshaft pipe.
Work on the propshaft should be carried out on a two-pillar lift
platform.
Before the removal, mark the position of all parts to each other.
Carry out the installation again in the same position, otherwise
the imbalance is too great, damages to the bearing and hum‐
ming noises could occur.
The front flexible disk on the propshaft and the corresponding
fixing screws are not available as a spare part. Thus in case
of damage, the entire propshaft must be replaced ⇒ Electronic
Catalogue of Original Parts .
Do not bend the propshaft, only store extended and transport.
When removing, do not let the propshaft »hang«, always sup‐
port it.
Always remove the propshaft horizontally from the centering
stud or push on.
Removing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
– Remove noise insulation ⇒ Body Work; Rep. gr. 50 .
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Removing the whole exhaust gas system ⇒ Engine; Rep. gr.
26 .
– Support propshaft with engine and gearbox jack e.g. -V.A.G
1383A- (as an aid, e.g. use a wooden wedge).
– Secure the propshaft against falling down with a belt.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
31
1. Propshaft

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents