Skoda Octavia II 2004 Workshop Manual page 78

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Raise the rear final drive -A- -arrow 1- and slide it as far to the
left as possible -arrow 2-.
– Remove the right drive shaft -B- from the flange and carefully
guide downwards.
– Move the final drive back into its installed position.
– Place a suitable wooden wedge -A- onto the universal support.
– Support the final drive with the engine and gearbox jack -
V.A.G 1383 A- , secure it with the belt on the universal support
against falling down.
– Release screw -B- at the front bracket.
– Remove the washer -C- from the top of the bracket.
– Swivel the final drive on the vehicle (see fig.) and at the same
time slightly lower.
– Disconnect the plug connection -A- on the four-wheel drive
control unit - J492- .
– Remove vent pipe -arrows- from the final drive.
– To remove, lower the final drive further and pull it towards the
front, ensuring adequate clearance to other components.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Secure the final drive with the belt of the universal holder
against falling down.
74
Rep. gr.39 - Final drive - rear differential
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.