Skoda Octavia II 2004 Workshop Manual page 127

• Do not tilt propshaft when removing, pull off horizontally from
centering stud of rear final drive. The gasket ring/centering
bushing -arrow- must not be damaged, otherwise the prop‐
shaft has to be replaced.
– Support propshaft with engine/gearbox jack , e.g. -V.A.G
1383A - .
– Tie up the rear part of the propshaft -A- for the suspension
-B- of the exhaust gas system.
– Disconnect plug connection -2-.
– Place catch pan under the final drive.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
123
6. Four-wheel drive clutch