Skoda Octavia II 2004 Workshop Manual page 121

– Check if a marking (colour point) is present on the flexible disk/
oscillation damper and on the flange of the four-wheel drive
clutch -arrows-. If not, mark the position of the flexible disk and
the flange on the four-wheel drive clutch to each other
-arrows-.
– Unscrew propshaft with flexible disk and oscillation damper
from rear final drive -arrows-.
When loosening and tightening, counterhold the propshaft on the
rear final drive.
– With the aid of a 2nd mechanic, press the engine/gearbox unit
forwards in -direction of arrow- and place a suitable wooden
wedge -A- (around 50 mm thick) between the assembly carrier
-B- and gearbox -C-.
– While doing so, remove the propshaft from the flange at the
four-wheel drive clutch (centering stud) on the rear final drive.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
117
6. Four-wheel drive clutch