Drain Off And Fill Oil For Four-Wheel Drive Clutch - Skoda Octavia II 2004 Workshop Manual

• Vehicle on level ground.
• Final drive in fitting position.
The oil temperature can be increased by warming up the engine.
Vehicles with aluminium assembly carrier
• If the oil gets onto the cross member or into the recesses at
the cross member, the oil must be removed immediately.
• Always place a cloth on the cross member -arrows-.
• There is no cross member on vehicles with steel assembly
carrier.
Continued for all vehicles
– Place a catch pan under the rear final drive.
– Unscrew screw for oil inspection -A-.
• The oil is at the correct level if the four-wheel drive clutch is
filled up to the lower edge of the oil filler hole.
– If necessary, top up high-performance oil for four-wheel drive
clutch
⇒ "6.5 Drain off and fill oil for four-wheel drive clutch",
page 107 .
– Screw in new plug -A- using a new sealing ring and tighten.
Tightening torques
♦ Oil inspection and filler plug
⇒ "5.1 Installation location overview - drain plug and check
screw", page 90
6.5 Drain off and fill oil for four-wheel drive
clutch
Special tools and workshop equipment required
♦ Filling device for four-wheel drive clutch - VAS 6291-
♦ Catch pan , e.g. -VAS 6208-
High-performance oil for four-wheel drive clutch ⇒ Electronic
Catalogue of Original Parts
Drain oil
– Raise vehicle.
– Place catch pan under the drain plug for the four-wheel drive
clutch -1-.
-2- - Oil filler plug for four-wheel drive clutch
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
107
6. Four-wheel drive clutch