Skoda Octavia II 2004 Workshop Manual page 32

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Check that the markings of the CV joint/propshaft arrows -A-
and -B- are present. If not, mark them with colours.
– Flange off the front propshaft pipe from the rear propshaft pipe
-arrows-.
– Push the front propshaft pipe to the front and swivel out the
flange of the rear propshaft pipe.
Note
When swivelling out make sure that the front propshaft pipe is
inclined as little as possible to the bottom.
– Carefully pull off the front propshaft pipe from the centering
stud.
Note
The gasket ring -arrow- in the cardan shaft flange must not be
damaged.
– Pull off propshaft horizontally from centering stud.
– Swivel down the front propshaft pipe and remove.
– Check if a marking (colour point) is present on the flexible disk/
oscillation damper and on the flange of the four-wheel drive
clutch -arrows-. If not, mark the position of the flexible disk and
the flange on the four-wheel drive clutch to each other
-arrows-.
28
Rep. gr.39 - Final drive - rear differential
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.