Mic With 20X1Ge Sfp Interfaces (Srx-Mic-20Ge-Sfp) - Juniper SRX5400 Reference

Supported slots
•
SRX5400–Any slot except bottom slot 0
•
SRX5600–Any slot except bottom slots 0 or 1
•
SRX5800–Any slot except center slots 0 or 1
Power Maximum of 570 W for the MPC with two MICs, including applicable transceivers.
requirement
NOTE:
•
To install and use SRX5K-MPCs in the SRX5600 and SRX5800 Firewalls, you must have
high-capacity power supplies (either AC or DC) and high-capacity fan trays installed in
the firewalls. All models of SRX5400 Firewalls already include high-capacity supplies. If
you do not have high-capacity power supplies and fan trays installed, the firewall will log
an alarm condition when it recognizes the SRX5K-MPCs.
•
On SRX5400 and SRX5600 Firewalls with AC power supplies, we recommend that you
use high-line (220 V) input power to ensure that the devices have adequate power to
support SRX5K-MPCs.
Weight Approximately 10 lb (4.5 kg) without MICs
LEDs OK/FAIL LED, one bicolor:
•
Green–The MPC is operating normally.
•
Blinking green–The MPC is transitioning to online or offline.
•
Red–The MPC has failed and is not operating normally.
•
Off–The MPC is powered down.
Serial number The serial number label is yellow and is located on the opposite side of the card.
location

MIC with 20x1GE SFP Interfaces (SRX-MIC-20GE-SFP)

You use Modular Interface Cards (MICs) and Modular Port Concentrators (MPCs) to add different
combinations of Ethernet interfaces to your firewall to suit the specific needs of your network.
The SRX-MIC-20GE-SFP MIC (see
twenty 1-Gigabit Ethernet small form-factor pluggable (SFP) Ethernet ports.
Figure 20 on page 45) can be installed in the SRX-5K MPC to add
44