Fan Installation - FPI I2450M Manual

Fan Installation

Installer: Please record unit serial number here before installing blower.
Serial No.______________________________
Your fan should only be installed once the unit is in place in order to
prevent any damage to the fan.
1. Attach the Left and Right Side Fan Facia to the Front Fan Facia by
aligning the Side Facia screw slots with the hole locations in the Front
Fan Facia and secure using 2 screws per side.
Front Fan Facia
Backside of Fan Facia shown
2. Once the Fan Facia has been assembled carefully slide the Fan into
position by centering the Fan below the Ashlip and align the Fan
Support Clips with the Offset Clips under the Ashlip.
Note: The Draft Control Rod is to fit through the top opening in
the Switch Plate.
Draft Control Rod
Switch
Plate
Left Side Fan
Facia
R i g h t S i d e
Fan Facia
Ashlip
Fan
Support Clips
IMPORTANT
Ensure that the Left and Right Side Fan Facia do not
hit the sides of the Faceplate when sliding the Fan into
position as the casting may chip.
If the spacing between the Side Fan Facia and the Face-
plate requires adjustment, the Side Fan Facia's can be
slightly pushed in or pulled out to fit accordingly.
3. Ensure the power cord and all other wires will not come into contact
with any hot stove surfaces.
DO NOT ROUTE POWER CORD UNDER
OR IN FRONT OF UNIT.
Do not turn the fan ON until your insert has reached oper-
ating temperature or at least 30 minutes after starting fire.
Neutral
Green
Live
Ground
120V AC
60 Hz
Fan Thermodisc
(normally open)
Black
Black
Blower/Fan Wiring Diagram
installation
Manual/
Fan
Auto
Switch
Switch
Black
Fan Fan
Regency HI2450M
|
19
Ground
| 19