Appliance Description; Appliance Dimensions - FPI I2450M Manual

Project # 19-469 Model: I2450M

Appliance Description

Model(s): I2450M, HI2450M
Additional Models Discussion: In addition to the tested model, this design is offered as
the HI2450M. The only difference between the two models is that the I2450M features a
formed steel fireplace fascia, while the HI2450M features a decorative cast iron fascia.
Both models use an identical design in all aspects that may affect emissions or air control
and are presumed to have the same emissions performance as the test specimen
provided for certification.
Appliance Type: Wood-Fired Fireplace Insert
Firebox Volume: 2.24 ft
3
Air Introduction System: Primary Air enters the firebox from the front bottom of the
appliance and is channeled up the sides on the appliance and down through the air wash,
as well as through a pilot air opening in the front of the firebox. Primary air is controlled
via a damper arm located below the ashlip which moves left (open) to right (closed).
Secondary air is pulled through a fixed opening in to rear bottom of the appliance and
channeled up through 4 secondary air tubes. Dimensions on all these features can be
found in Appendix D.
Baffles: A pair of mating 9.438" x 15.0" x 1.00" vermiculite panels mate together to form a
baffle which rests on top of the secondary air tubes.
Refractory Insulation: The firebox is lined with 1" thick firebrick.
Flue Outlet: 6-inch exhaust outlet located on the top of the appliance.
Catalytic Combustor: N/A
Fan: The I2450M is equipped from the factory with a convection fan that attached to the
front of the appliance beneath the loading door.

Appliance Dimensions

I2450M Unit Dimensions
Height Width Depth Firebox Volume Weight
22" 35" 28" 2.24 ft 3 330 lbs
Appliance design drawings can be found in Appendix D submitted with the CBI copy of
this report.
Page | 10