Installing Your Insert - FPI I2450M Manual

installation
|
10
STOP! PLEASE READ CAREFULLY.
CAST COMPONENTS ARE VERY FRAGILE.
USE EXTREME CARE WHEN HANDLING.

Installing Your Insert

Your insert is very heavy and will require two or three people to
move it into position.
1. Remove the door to make the insert easier to handle. To remove the
Door, open fully and lift it up off its hinges.
Refer to the Door Removal section for an important note on installa-
tion.
2. NOTE: For Masonry installation make sure that the firebox is level
with the hearth using non-combustible materials and no more than
1/2 to 1 inch of the levelling bolt.
3. Lift the unit up onto the Hearth and slide into the fireplace opening.
Be sure to leave the unit out at least 3 to 4 inches in order to make
the necessary flue connections and to install the faceplate.
Be sure to protect your hearth extension during the installation,
ie. with a heavy blanket.
10 |
Regency HI2450M
Hinges
Door
WARNING
DO NOT LIFT OR PUSH THE UNIT FROM THE ASH-
LIP, LEFT SIDE CAST or RIGHT SIDE CAST. THE
CASTING WILL CHIP OR BREAK.
Left Side
Cast
Ashlip
DO NOT LIFT UNIT FROM THESE PARTS.
Right Side
Cast